停车场遥控器对码说明
控制器对码说明 Code Instruction of Remote Control
步骤一:同时按住手动上和下按钮上电,道闸进入对码状态
Step 1: To press the Manual up and down button at the same time, the barrier enters the state of code.
步骤二:上电后的两秒内,按下需要对码的遥控器按钮
Step 2: Within the two seconds of power on, press the related button of remote control which need to code.
步骤三:对码成功,编码将自动记录,通行指示灯闪亮一秒后熄灭,自动进入步
骤四;若对码不成功,原储存编码不会被改变。通行指示灯快速闪亮三秒后熄灭,
进入步骤四。
Step 3: After coding successfully, the code will be recorded automatically, the showing light will be off after one second, then enter to the step 4 automatically; If the code not successfully, the former code will not be changed. The showing light will be off after three seconds, then enter to step 4.
步骤四:进行第二个遥控器的对码,操作方法及状态指示同步骤三,该过程结束
后将自动进入步骤五。
Step 4: In process of coding of the second remote control, the operation and showing state is same as the step 3; this process finish will enter into the step 5 automatically. 步骤五:进入第三个遥控器的对码,操作方法及状态指示同步骤三,该过程结束
后将自动退出对码模式。
Step 5: In process of coding of the third remote control, the operation and showing state is same as the step 3, after finishing this process will exit the coding mode automatically.
若需要保留已有的某个或全部编码,对码时可在步骤三,四,五不做操作。每个
对码步骤若超过两秒,该步骤将自动退出,该道闸最多储存三个不同的编码。
If keeping the ready some or all code, can not do the operation in the coding of step 3, 4 and 5. If each coding process is over 2 seconds, this process will exit automatically. The barrier can keep three different codes at most.