窍门一: 除尘布袋的堵塞.布袋发生堵塞时,使阻力增高,可由压差计的读数增大表现出来.布袋堵塞是引起布袋磨损,穿孔,脱落等现象的主要原因.引起除尘布袋堵塞的原因,按下表进行检查并维修.一般采取下列措施: a.暂时地加强清灰,以消除布袋的堵塞, b.部门或全部更换布袋, c.调整安装和运行前提.
窍门二: 除尘布袋的老化.主要因为以下原因引起的,须进行原因调查,采取消除措施并更换除尘过滤袋. a.因异常高温而硬化收缩, b.因与酸,碱或有机溶剂的蒸气接触反应, c.与水分发生反应.
窍门三: 滤布不宜挂得过松或过紧,过松轻易积尘,过紧轻易拉坏.更换下来的除尘器布袋,先用压缩空气吹净,再检查有无破洞,有破洞修睦后留待更换.如被粉尘糊住的布袋,用水冲刷,凉干后留待更换.
Tip one:
Clogging dust bag. Bags clogging, so that increased resistance by increasing the differential pressure gauge readings manifested. Toi Toi blockage is caused by abrasion, perforation, fall off and so the main reason for the cause blockage caused by dust bag, press tables check and repair.
Generally take the following measures:
a. temporarily enhanced cleaning to eliminate clogging of the bag,
b. department or replace all bags,
c. adjust the installation and operation of the premise.
Tip two:
Dust bag aging, mainly due to the following causes, reasons must be investigated, to take measures to eliminate and replace the dust filter bags.
a. due to abnormal high temperature curing shrinkage,
b. due to acid, alkali or organic solvent vapor contact reaction,
c. and water react.
Tip three:
Cloth should not hang too loose or too tight, too loose dust easily, too tight to easily pull the bad. Replaced the dust bag, first with compressed air blowing, and then check for holes, have holes repaired after replace left as is dust paste lived bag, water erosion, dry it left replacement.