奥林巴斯微单进工程模式查看快门次数
来源:聚乐网,作者:kingking
Checking shutter count on E-p1, E-P2, E-PL1 & E-PL2
By following these steps you can check your shutter count as well as a few other things. Follow these steps:
1. While holding the "Menu" button, press Power button to switch on
按住Menu键的同时按电源键
2. Press "Menu" and go to "Monitor brightness adjustment" screen
按Menu进入菜单,进入屏幕亮度调整
3. Press "Info" and "OK" button at same time, you will see the screen showing "Olympus"
同时按住Info和OK键,这时你应该可以看到屏幕上显示Olympus...
4. Press the following buttons in the sequence: Up, Down, Left, Right and then press the Shutter, followed by Up (dial button in my E-P2)
按顺序按下:上,下,左,右,快门,上,你就能进入工程菜单了
5. Engineering mode page is seen. Press dial button to Page 1, 2, 3, and "D".
通过上下左右键进入Page1, 2, ,3, D
6. Shutter count is on "Page 2" under "R".
其中,Page 2的R 显示的就是快门数。
The other lines on the screen mean:
R: shutter release count 快门数
S: flash use count 闪光数
C: CMOS cleaning mode (with mirror lock-up - in E-410 series)
U: number of ultrasonic dedusting, ~ number of power switch on 自动除尘数(相当于电源开关次数)
V: number of use of LiveView 使用Liveview的次数
B: number of shot using In-Body Stablization 使用防抖的次数
Please be careful when doing this. Although it's probably perfectly safe to do this i hold no responsibility if you mess up your Pen.