新福克斯 自动落锁

新福克斯 自动落锁 The enable/disable mode is entered when the following series of steps is performed. Install Time: Difficulty Level: 5 Minutes 1 Directions: 输入使能/禁用模式下时，执行下面的一系列步骤。 安装时间:难度级别: 5分钟1 行车路线: Step 1 Confirm that the perimeter alarm is disarmed. 确认车辆安全停放 Step 2 Close all doors. 关闭所有车门 Step 3 Confirm that the ignition switch is in the OFF position. Note: Steps 4 through 8 must be performed within 30 seconds. 确认车辆点火开关处于关闭状态 注意:第四步骤到第八步骤必须在30秒内完成 Step 4 Turn the ignition switch from OFF to RUN. 将点火开关从关闭到打开状态，不要着车。 Step 5 Press the power door lock UNLOCK button three times. 将车门锁连续按动3次 Step 6 Turn the ignition switch from RUN to OFF. 将车辆点火开关从打开到关闭状态 Step 7 Press the power door lock UNLOCK button three times. 将车门锁连续按动3次 Step 8 Turn the ignition switch from OFF to RUN. 将车辆点火开关从关闭到打开状态 Step 9 Verify that the RAP module chirps the horn. This indicates that the RAP module is now in the enable/disable mode and ready to accept program changes. 这时车喇叭会发出短鸣声，说明行车电脑模块已经进入可编辑状态。 Step 10 Press the power door lock UNLOCK button one time to command the RAP module to toggle the autolock/relock feature ON or OFF. 按车门锁一次，以触发行车电脑模块的自动锁生效或取消。 Step 11 Press the power door lock LOCK button once to enter the command. 按车门锁一次执行指令。 Step 12 Verify that the vehicle horn chirps one time to signal the RAP module confirmation of the command. There should only be one chirp indicating that the autolock/relock feature has been disabled. If one chirp is heard, followed by a longer honk, the autolock/relock feature has just been enabled. Return to step 10. 这时会听到一声短鸣声，说明行车电脑模块指令已经执行。 应该只有一声短鸣声，明自动锁闭/重新锁定功能已被禁用。 如果一个短鸣声，接着一个较长的按喇叭，自动锁定/重新锁定功能的刚刚启用。 返回到第10步。 Step 13 Turn the ignition switch to the OFF position to exit the enable/disable mode. 将车辆点火开关转到关闭状态，退出编辑模式。 Step 14 Verify that the RAP module chirps the horn once to indicate that a feature has been changed. 会再听到一声短鸣声，表示设置成功。