孟鲁司特钠 BP质量标准

Montelukast Sodium General Notices (Ph. Eur. monograph 2583) C35H35CINNaO3S    608.0    151767-02-1 Action and use Leukotriene CysLT1 receptor antagonist; treatment of asthma. Ph Eur DEFINITION Sodium [1-[[[(1R)-1-[3-[(E)-2-(7-chloroquinolin-2-yl)ethenyl]phenyl]-3-[2-(1-hydroxy-1-methylethyl)phenyl]propyl]sulfanyl]methyl]cyclopropyl]acetate. Content 98.0 per cent to 102.0 per cent (anhydrous substance). CHARACTERS Appearance White or almost white, hygroscopic powder. Solubility Freely soluble in water and in methylene chloride, freely soluble to very soluble in ethanol (96 per cent). IDENTIFICATION A. Infrared absorption spectrophotometry (2.2.24). Comparison  montelukast sodium CRS. B. Enantiomeric purity (see Tests). C. Ignite 0.1 g in a crucible until an almost white residue is obtained. Take up the residue in 2 mL of water R and filter. The filtrate gives reaction (a) of sodium (2.3.1). TESTS Enantiomeric purity Liquid chromatography (2.2.29). Carry out the test protected from light. Prepare the solutions in amber flasks. Solvent mixture  acetonitrile R, water R (50:50 V/V). Test solution  Dissolve 50 mg of the substance to be examined in the solvent mixture and dilute to 50.0 mL with the solvent mixture. Reference solution (a)  Dilute 1.0 mL of the test solution to 100.0 mL with the solvent mixture. Dilute 1.0 mL of this solution to 10.0 mL with the solvent mixture. Reference solution (b)  Dissolve 5 mg of montelukast racemate CRS in the solvent mixture and dilute to 50.0 mL with the solvent mixture. Column: · — size: l = 0.15 m, Ø = 4.0 mm; · — stationary phase: silica gel AGP for chiral chromatography R (5 µm); · — temperature: 30 °C. Mobile phase: · — mobile phase A: 2.3 g/L solution of ammonium acetate R adjusted to pH 5.7 with glacial acetic acid R; · — mobile phase B: acetonitrile R, methanol R (40:60 V/V); Flow rate  0.9 mL/min. Detection  Spectrophotometer at 280 nm. Injection  10 µL. Relative retention  With reference to montelukast (retention time = about 25 min): impurity A = about 0.7. System suitability: · — resolution: minimum 2.9 between the peaks due to impurity A and montelukast in the chromatogram obtained with reference solution (b); · — signal-to-noise ratio: minimum 10 for the principal peak in the chromatogram obtained with reference solution (a). Calculate the percentage content of impurity A using the following expression: r1  =  area of the peak due to impurity A in the chromatogram obtained with the test solution; r2  =  sum of the areas of the peaks due to montelukast and impurity A in the chromatogram obtained with the test solution. Limit: · — impurity A: maximum 0.2 per cent. Related substances Liquid chromatography (2.2.29): use the normalisation procedure. Carry out the test protected from light. Prepare the solutions in amber flasks. Solvent mixture  water R, methanol R (10:90 V/V). Test solution (a)  Dissolve 50.0 mg of the substance to be examined in the solvent mixture and dilute to 50.0 mL with the solvent mixture. Test solution (b)  Dilute 10.0 mL of test solution (a) to 100.0 mL with the solvent mixture. Reference solution (a)  Dilute 1.0 mL of test solution (a) to 100.0 mL with the solvent mixture. Dilute 1.0 mL of this solution to 20.0 mL with the solvent mixture. Reference solution (b)  Dissolve 10 mg of montelukast for peak identification CRS (containing impurities B, C, D, E and F) in the solvent mixture and dilute to 10.0 mL with the solvent mixture. Reference solution (c)  In order to prepare impurity G in situ, transfer 1 mL of reference solution (b) to a colourless glass vial and expose to ambient light for about 20 min. Reference solution (d)  Dissolve 65.0 mg of montelukast dicyclohexylamine CRS in the solvent mixture and dilute to 50.0 mL with the solvent mixture. Dilute 10.0 mL of the solution to 100.0 mL with the solvent mixture. Column: · — size: l = 0.05 m, Ø = 4.6 mm; · — stationary phase: phenylsilyl silica gel for chromatography R (1.8 µm); · — temperature: 30 °C. Mobile phase: · — mobile phase A: mix 1.5 mL of trifluoroacetic acid R and 1000 mL of water R; · — mobile phase B: mix 1.5 mL of trifluoroacetic acid R and 1000 mL of acetonitrile R; Flow rate  1.2 mL/min. Detection  Spectrophotometer at 238 nm. Injection  10 µL of test solution (a) and reference solutions (a) and (c); 20 µL of reference solution (b). Identification of impurities  Use the chromatogram supplied with montelukast for peak identification CRS and the chromatogram obtained with reference solution (b) to identify the peaks due to impurities B, C, D, E and F; use the chromatogram obtained with reference solution (c) to identify the peak due to impurity G. Relative retention  With reference to montelukast (retention time = about 7 min): impurity C = about 0.4; impurity G = about 0.8; impurities D and E = about 0.9; impurity F = about 1.2; impurity B = about 1.9. System suitability  Reference solution (c): · — resolution: minimum 2.5 between the peaks due to impurity G and montelukast; minimum 1.5 between the peaks due to montelukast and impurity F. Limits: · — impurity B: maximum 0.3 per cent; · — impurity C: maximum 0.2 per cent; · — impurities F, G: for each impurity, maximum 0.15 per cent; · — sum of impurities D and E: maximum 0.15 per cent;26.369/ · — unspecified impurities: for each impurity, maximum 0.10 per cent; · — total: maximum 0.6 per cent; · — disregard limit: the area of the principal peak in the chromatogram obtained with reference solution (a) (0.05 per cent). Heavy metals (2.4.8) Maximum 10 ppm. Solvent mixture  water R, acetone R (20:80 V/V). 0.50 g complies with test H. Prepare the reference solution using 0.5 mL of lead standard solution (10 ppm Pb) R. Water (2.5.12) Maximum 4.0 per cent, determined on 0.300 g. ASSAY Liquid chromatography (2.2.29) as described in the test for related substances with the following modifications. Injection  Test solution (b) and reference solution (d). Calculate the percentage content of C35H35ClNNaO3S using the following expression: A1  =  area of the principal peak in the chromatogram obtained with test solution (b); A2  =  area of the principal peak in the chromatogram obtained with reference solution (d); m1  =  mass of the substance to be examined used to prepare test solution (a), in milligrams; m2  =  mass of montelukast dicyclohexylamine CRS used to prepare reference solution (d), in milligrams; p  =  declared percentage content of montelukast dicyclohexylamine CRS; a  =  percentage content of water in the substance to be examined. STORAGE In an airtight container, protected from light. IMPURITIES Specified impurities  A, B, C, D, E, F, G. Other detectable impurities (the following substances would, if present at a sufficient level, be detected by one or other of the tests in the monograph. They are limited by the general acceptance criterion for other/unspecified impurities and/or by the general monograph Substances for pharmaceutical use (2034). It is therefore not necessary to identify these impurities for demonstration of compliance. See also 5.10. Control of impurities in substances for pharmaceutical use): H, I. A. [1-[[[(1S)-1-[3-[(E)-2-(7-chloroquinolin-2-yl)ethenyl]phenyl]-3-[2-(1-hydroxy-1-methylethyl)phenyl]propyl]sulfanyl]methyl]cyclopropyl]acetic acid, B. [1-[[[(1R)-1-[3-[(E)-2-(7-chloroquinolin-2-yl)ethenyl]phenyl]-3-[2-(1-methylethenyl)phenyl]propyl]sulfanyl]methyl]cyclopropyl]acetic acid, C. [1-[[[1-[3-[(E)-2-(7-chloroquinolin-2-yl)ethenyl]phenyl]-3-[2-(1-hydroxy-1-methylethyl)phenyl]propyl]sulfinyl]methyl]cyclopropyl]acetic acid, D. 1-[[[(1R)-1-[3-[(1R)-1-[[[1-(carboxymethyl)cyclopropyl]methyl]sulfanyl]-2-(7-chloroquinolin-2-yl)ethyl]phenyl]-3-[2-(1-hydroxy-1-methylethyl)phenyl]propyl]sulfanyl]methyl]cyclopropyl]acetic acid, E. 1-[[[(1R)-1-[3-[(1S)-1-[[[1-(carboxymethyl)cyclopropyl]methyl]sulfanyl]-2-(7-chloroquinolin-2-yl)ethyl]phenyl]-3-[2-(1-hydroxy-1-methylethyl)phenyl]propyl]sulfanyl]methyl]cyclopropyl]acetic acid, F. [1-[[[(1R)-3-(2-acetylphenyl)-1-[3-[(E)-2-(7-chloroquinolin-2-yl)ethenyl]phenyl]propyl]sulfanyl]methyl]cyclopropyl]acetic acid, G. [1-[[[(1R)-1-[3-[(Z)-2-(7-chloroquinolin-2-yl)ethenyl]phenyl]-3-[2-(1-hydroxy-1-methylethyl)phenyl]propyl]sulfanyl]methyl]cyclopropyl]acetic acid, H. [1-[[[(1R)-1-[3-[(E)-2-(7-chloroquinolin-2-yl)ethenyl]phenyl]-3-[2-(methoxycarbonyl)phenyl]propyl]sulfanyl]methyl]cyclopropyl]acetic acid, I. (2RS)-[1-[[[(1R)-1-[3-[(E)-2-(7-chloroquinolin-2-yl)ethenyl]phenyl]-3-[2-(1-hydroxy-1-methylethyl)phenyl]propyl]sulfanyl]methyl]cyclopropyl](hydroxy)acetic acid. Ph Eur